Posts by charliecarol
-
-
Keep going it should work
-
Had same issue found sd card slot bad replaced then ok some of the pins were smashed.
-
step 1 is only on that line menus, setup, type, passwords user
-
Try this
1. Press menus, select setup, select password, press f2 user,
the first name will be the install username
press enter and type in the install username then press enter again
choose a password and type it in then type it in again to comfirm
Once the password has been comfirm you will be asked if you want to log in select YES
at this point you should see the @ symbol next to the username, indicating that you are logged in
press prev key
change (default user timeout and timeout occurs in) to zero
cycle power then follow step1 to log in again as install
cycle pwer again
upon power up the install user should automatially be logged in enabling the user to perform any function
on the teach pendant -
fanuc does have a procedure that the pass word can be defeated. If you still need it I will send it to you
-
Having trouble with robot pausing for 3 seconds on joint moves after I change the configuation of J5 with the CNT . If I use fine it is ok. But cycle time is not fast enough. Any Ideas????