Posts by sccrcoach
-
-
yes I have a manual...will have to check software version tomorrow at work
-
There are no other alarms...i also have a M30ia that has the same problem cannot reset error 003
-
I have a 20001b robot with an RJ3iC controller and I cannot reset the deaman switch all the time...it is intermittent and the cable and teach pendant has both been changed...any ideas what can be causung this....help will be greatly appreciated
-
I have 2 used 2000ia robots with RJ3iB controllers....both have profibus cards installed from previous owner...when I try to power up as stand alones I get a PROF-012 error Slave not existent(5)...is there any way to disable this...any help will be greatly appreciated...just removin g the board does not help
-
I did this and it is still there....removing the profibus card started this whole problem
-
I recently powered up 2 robots with profibus cards in RJ3 controllers....I physically removed the profibus card now I get a DI/O not recovered. and INTP 206...how can I disable to remove the card from memory and get these robots running...any help will be greatly appreciated
-
When I try to start up this robot as a stand alone for testing I get the following errors....
INTP-207 (FLT_RSET,1) Group I/O port access and
INTP-206 (CK_LAY,!) Digital port accessthis robot used to be in a cell and now I am testing it as a stand alone....any help will be greatly appreciated
-
That took care of it thanks
-
When I power on my Rj3iB controller I get this pesky analog port access error INTP-2-5 (Z_pos,1)...I am at a total loss of how to deal with this as the robot will not run in teach....it just sits there like an expensive paperweight....any help will be greatly appreciated
-
When I power up my used robot with a RJ3 controller I cannot move it because of a PRIO 225 - Consumer Timeout - ID:1 error.....how can I get out of this plz...any help will be greatly appreciated
-
Thanks everyone it turned out that I had 420iF software for a 420iW...reloaded software and it works fine
-
That is the problem....the 4th axis moves and the faceplate does not stay on the same plane.
-
Does anyone know where I can get a copy of the software for this robot with a rj2 controller...thanks
-
I have 2 s420iW robots with RJ2 controllers and when I try to run them in world frame the Y axis moves side to side but also the #4 axis moves with it....what is the problem...any help will be appreciated
-
Is there anywhere that I can get pinouts for the robot cables...any help will be greatly appreciated
-
I have to build some robot cables and was wondering if anyone knows where to buy the end connectors for them? also the cable....any help would be greatly appreciated
-
I have a 100iB robot with a RJ3iB controller and when I power it up I get this error srvo-136-DCLVAL alarm...any help will be appreciated.