Posts by happytriger2000

Hello again,
I have checked the 4 pins and 2 of them(pin 2 and 4) for sure are 24V and Gnd:

and indeed the pin arrangement are the same as KRC1 pin header:

To show your pictures you need to upload your selected images to a Image hosting service, for eg. Imageshack, photobucket,..so on, once uploaded you wil get this:

copy the "IMG code" and paste it to your massage board:

done!!
Tops: when uploading pictures I usually reduce it to 50% of its original size for faster upload.

I don't remember If I have that cylinder, I will check it soon.
Someone advise me to replace the X32 to this:

and I would like to know if its ok to do so?, I don't want any smoke coming out of the board.

Some picture I took inside of the KR2210 X02 box:

Hi RAS-Skordos GR,
I bought this used EMT last year for my KRC1 and now I have a newer KR210 s2000 KRC2 (2004) installed and need mastering.
"Maybe the adapter is already screwed on the cable and you missed it"

Will check the connector tomorrow,

thanks

Somehow the link was not working, have a look at the picture below:

Hi,
I have an EMT set: [url=http://i1220.photobucket.com/albums/dd459/h…trial/EMT/2.jpg,]http://i1220.photobucket.com/albums/dd459/h…trial/EMT/2.jpg,[/url] and I want to master KR2210 S C2 but the X32 connector is different to the connector of the cable: [url=http://i1220.photobucket.com/albums/dd459/h…trial/EMT/2.jpg,]http://i1220.photobucket.com/albums/dd459/h…trial/EMT/2.jpg,[/url] is there an adapter for this?

thanks

Hello,
File extension for kuka is .SRC, for Fanuc is .LSI What is the file extension used for Panasonic Robots?,

thanks all

Hi everyone,
Im thinking of taking KUKA training course in Taiwan, although Industrial robot is quite new to me but Im very interested in this field, can anyone out there give some advices before taking this course, Thank you,

CS Chang