Morning, ERROR 5211 : EXDS signal is OFF
What could be the problem and how to resolve it, I cancel it and it dissappears but when I switch the servo ON it pops up again and there's nothing I can do to jog the robot.
Please assist!!!
Morning, ERROR 5211 : EXDS signal is OFF
What could be the problem and how to resolve it, I cancel it and it dissappears but when I switch the servo ON it pops up again and there's nothing I can do to jog the robot.
Please assist!!!
Can someone assist me with this, the wire doesn't feedout when pressing button f6/9 and as such when i press play button to weld it gives me wire sticking/short with a code 9001. How do i resolve this in order for me to weld?
Manual doesn't address the issue other than to show how to view what kind of alarm it is (User alarm system) that's it, now i can't continue to weld 🤷
I must also highlight that the wire feeder buttons does feed out and pull the wire, problem is just from the pendant or when i press play to start welding it stop and says missing arc action...
Good Evening doomedblue i also tried that but nothing is happening the shock sensor doesn't want to go away...
The shock sensor is a normally closed circuit that leaves the controller and goes out to the safety clutch and through a switch in the clutch then back to the controller. If you are getting alarm 4110 this circuit is open and you must trace it out and close the circuit. It may be the safety clutch is not in the proper socket and therefore tripped.
I'm using DX100 for plasma cutting, whilst it was in the process of cutting it stopped and showed 4110 alarm shock sensor. Did everything I could to remove the alarm through OVERRUN & S.SENSOR but still after releasing and going back to the JOB it pops up again, I really ran out of ideas what to do now. PLEASE ASSIST !!!