The problem was resolved!! We change this board.
Thanks
The problem was resolved!! We change this board.
Thanks
The problem was resolved.
In maintenance mode.
Thanks a lot.
Can you start-up in maintenance mode?
Yes, aND not change.
Can you start-up in maintenance mode?
I can try, I saw the failure at last minute Yesterday. I'm going to the plant and will try.
And will see the leds in the controller, y read about two LEDs for system ok.
Hello, I have one Yaskawa NX 100 and received one Preventive I saw das disconnected and connected the cables in the terminals board and cleaning with air all cards in the panel.
And now the Pendant don't pass to the la initial image.
I think that it's don't boot.
What can be?
Is the SGDR-FBA 01A the green battery board in the base of the robot? If so, then yes, you should have 5 Vdc on pins 2, 4, 6, 8, 10, and 12 on the 32 pin connector of the robot harness.
Yes it is. We will buy one. And pray.
Thanks
Hello:
I have the next message in the teach
ALARAM 1325
COMUNICATION ERROR (ENCODER)
ROBOT1(SLURBT)
And reading the blog I did some test:
I changed the 1BC cable, and the AXA card.
I saw that the card SGDR-FBA 01A I have 24 Vcd in the input but I don't have 5 V for enconders, only the battery output.
This is a possibe problem?
Thanks
pd: I'm sorry for my bad English
Hello:
I have the next message in the teach
ALARAM 1325
COMUNICATION ERROR (ENCODER)
ROBOT1(SLURBT)
And reading the blog I did some test:
I changed the 1BC cable, and the AXA card.
I saw that the card SGDR-FBA 01A I have 24 Vcd in the input but I don't have 5 V for enconders, only the battery output.
This is a possibe problem?
Thanks
pd: I'm sorry for my bad English