Posts by Edu.

Hi!

Thank you very much for the information, now I can move it!

Hi everywone,

I need some help with a few problems with my new fanuc robot.

It started with "SRVO-062 BZAL alarm" in all axis. But that was solved.

After that someone made changes on "System - Master Cal", but im not sure which ones. Press "Yes" on some of these:

1. FIXTURE POSITION MASTER

2. ZERO POSITION MASTER

3. QUICK MASTER.

6. SET QUICK MASTER REF.

7. CALIBRATE.

The robort wasn't in zero position.

Now robot just make some noise and vibrations, and then shows "SRVO-050 Collision Detect alarm (G:1 A:3)", and "SRVO-053 Disturbance excess (G:1 A:3)." The robot could move in JOINT mode before de changes.

Also shows the warning "Payload Configuration Not Complete".

I think the robot thinks it's in a collision with itself, due to a bad position/zero calibration, but I have no idea. Can anyone help?