Thanks guys for all the Info I've learned a lot on here!
Posts by Sbeve2020
-
-
Nation Thank you so much that was great! SO Karrel just means the roboguide program into the TP.
-
Sergei Troizky I hear a lot about Karrel's here any tips to get a basic understanding?
Like what do you program it with then how do put it on the TP
-
-
I'm still looking for a VM so I can just practice on D:
-
Adam is very good here's some good Youtuber's for all PLC stuff to get started or even I would say master? Plc will always be with robot's "Mostly"
1. https://www.youtube.com/@realpars
2.https://www.youtube.com/@TimWilborne
3. https://www.youtube.com/@SolisPLC
4. https://www.youtube.com/@EASYPLCTRAINING (Good visuals)
5. https://www.youtube.com/@ShaneWelcher
Factory I/O is a good cheap version to sim
-
So uh what was the fix?
-
NeySEA Adam Willea On YouTube is a great start into robo and will help you a lot and have a lot of examples
-
I've had this before and just had to change a couple points because the robot is on the edge of glory
-
This might help?
I know for ours that's how we bypassed our fence so we could work on the robot. But our robot is old and I know noting about cobots and that's more wires then what was in ours. I would probably call Fanuc.
-
When I did my I/O this was my rack 48 and how I would wire in DI DO
-
I mean don't let them use the TP is probably going to be ur best bet. I know you can set up some like HML screen on the Tp so they can only do some stuff.
-
DS186 Sweet I've set up the IP before but never realize this Surprised there not a video on YouTube when I looked it up! Thanks
-
I mean I could be dumb but I really don't know if there is a way to do that ^^^^ it would be cool to have like a remote desk option on the Fanuc to connect to ur pc and fix easy things. If anyone knows that would be some good info
-
-
Hm odd I was having this one time but it was throwing some code at me and I couldn't do anything so I factory reset it and online the only answer was Karel program but I wasn't running any Karel programs. I'm guessing if it's that it would have to be your controller if it isn't letting you do anything or throwing codes but I'm not for sure.
-
Are you running any Kale programs in the back ground?
-
I used all move J's and I like the way it turned out tbh
-
Hey, guys I'm doing to program with a circle and gluing and I haven't tried to make it yet . I was just wondering what would be the best way to attack this guy. I can handle all of the I/O, Just wondering how I should do the lines they have to be super close to the edge of it because of the glue. Any help would be great! The red parts are where the robot is running the glue. There about a 1inch.
-
HawkME Ok I'm going to mess with it again today still trying to make it perfect tanks again hawk