It worked exactly as I wanted.
Thank you very much for your help
Best regards
It worked exactly as I wanted.
Thank you very much for your help
Best regards
Was it that simple?
Thank you very much, testing it tomorrow!
Best regards
You can edit and modify your programm directly on the SP1.
- Make a backup
- Menu/Application Manager/Val3 application/...your application.../Programs/...you program...
- Edit
Don't save before to test you modification...
That part I’ve got so far. The thing is, after I’m inside the program and I’m with the cursor over an instruction , there is no edit button to edit the specific instruction. Only solution I found was insert a new one and delete the older one.
Hello,
Close it and open it again. This will reload it too (Just opening might also be enough).
Probably the "Reload" function has been added to newer SRC versions than what your controller is running.
Hello.
I'm pretty sure I tried that when the problem occured.
However, as soon as I make some changes again on the PC and I need to test the function, I will try this method again
Best regards
Display MoreHi,
Yes, you don't need to power cycle the controller.
You just need to reload the application.
Press the menu button on the pendant and go to the application manager.
Move down to the opened application and press F5 or F6 to reload the application.
If the application is running, first press stop to stop it, then reload it, then press start again.
If you don't reload the app the robot will run always the same, it needs to be reloaded to load the new changes.
Hello.
I don’t think I have the reload option on this console.
See picture attached
Best regards
Hello everyone.
Does anyone know if it's possible to edit a instruction on the teach pendant of an RX130(CS8)?
There's some changes I need to make to an application but all i've been doing so far is copying/pasting the instructions, make the changes on the new ones(which appear as editable) and delete the older ones.
Is there not an edit button? Can't find it
Thanks
Best regards
Hi,
I don't know exactly what happened to the forum, but I did reply to this yesterday...
Is this CS7? I'm not too familiar with CS7, but I have a retired friend who might help you.
Let me reach him...
Hello again.
Sorry for the delay.
The controller is a CS8 (RX130BL)
Best regards
Hello my friend.
I’m not quite sure, I’ll check on Monday when I’m back to work!
Best regards
Hello everyone .
What’s the best way to reboot a staubli teach pendant. The robot is rx130.
We made some changes in the program through FTP surfer on our PC, however the changes did not download to the controller. The only way we managed to do it is to restart the controller on the electrical panel , through the “security switch “ which is not ideal.
I think If we only restart the teach pendant it might be enough
Is there another safer way to send the changes to the controller ?
Best regards