Posts by flame
-
-
I'm working on setting up i/o for the media flange. I believe I set it up correctly in workvisual 5.0 and my i/o group shows up on the teach pendant. I am getting the error "Error during stack initialization ... no network response]. Seems to be the same as other people. I haven't been able to figure out physical connections yet with confidence. Can someone confirm that the x65 port on the controller should connect to the x651 port on the bottom of the lbr med 14 robot I have? And then I see x76 is used to power it... but I'm not quite sure what that power source is (the controller? the wall?). As of now my goal is to get a signal at the media flange (on a multimeter) which will then lead into picking an end effector.
-
I am just trying to get some sort of input/output at the inside electrical components of the media flange. So I have added the media flange option. Restarting or deleting and putting x44 back both did not change anything. I am using workvisual 5.0. I have a lbr med 14 robot and a MF Inside elektrisch MFD. I'm not positive I need the ethercat option but I and currently blindly following any sort of instructions I can find online. Would I need to connect the control box to the bottom of the arm? I believe I need to connect x65 to x651? And the also connect x76 to something (not sure what)? Any pointers in the right direction are appreciated!
-
Hello,
I am new to this stuff and the instructions posted were really helpful. I am stuck because I don't have an EtherCat option beneath the SYS-x44 bus. Any ideas on how to make this appear?
-
I am trying to jog a lbr med 14 with the 6D mouse. When holding in the button I can jog using the buttons on the smartpad, but there is no option for the mouse. After digging I found a warning saying "Illegal 6D mouse position. 6D mouse is not activated. Reading data is not possible" I've tried to find documentation on activating the mouse but have not had luck. Currently using Sunrise.OS Med 1.15 V1