Im adding some code on a robot with version 7.7 how to i do the auto update? The rest was pretty similar to the new version.
Posts by Cboone03
-
-
For the project I just did I used a pounce program to call when my application program was complete to put me back over my conveyor. After your sysend you can create a condition to call the pounce program. Or Call you application again. Plus in your job setting there's a spot that allows you to select step, 1 cycle or auto. Auto will bring you back to the beginning of whatever program your running. I forget where that is tho
-
It's funny this popped up today, for the fact I literally just got back from the install which was a success.
-
Hello All,
I'm new to yaskawa and I'm setting up a line tracking system to simply set and wait for a mold to come by then follow the mold and dispense foam in it while the conveyor it moving. I only have one trigger sensor and I need to start following it when my trigger is made. The track is constantly going the same direction so I'll need the robot to go back to the start position when the next part trips the trigger and follow the speed again.
It appears to be tracking but not straight across. It moves on an angle sometimes.
I feel like it has to do with my lack of understanding with the conveyor calibration. I've taught different points like a frame there but it tells me they are all the same. Then I try moving the encoder and teach different points it sometimes takes it.
Any help would be greatly appreciated.
-
Thank you all for your help I will try to force the $[1025] and see if that gets me moving. Yes I will do a backup first. Thank you everyone.
-
2nd picture
-
-
I picked up a second hand kuka kr 10 r1100-2. Smartpad is a krc4 with 8.3. It still has the previous project on it. I curruntly dont have it connected to a plc. It came with what appears to be a jumper of sorts but im not sure. I only have the 3 warnings. Is there a way to bypass the plc for now?
The pictures attached are with the dead man pulled in.