Hi, no the problem is not solved.
Yaskawa nordic is trying to solve it.
Hi, no the problem is not solved.
Yaskawa nordic is trying to solve it.
Hi here comes the TASK part from SYS.cfg.
I got it working when I loaded the module in TASK 1 but when I moved it back to TASK 2 I got the same problem again. Then tried to move it back to TASK 1 but then the same problem occurred there as well.
#
CAB_TASKS:
-Name "MAIN" -Type "NORMAL"
-Name "Ewab_In" -Prog 1 -Task_in_forground "MAIN" -Type "NORMAL"\
-TrustLevel "None"
-Name "Ewab_Ut" -Prog 2 -Task_in_forground "Ewab_In" -Type "NORMAL"\
-TrustLevel "None"
Hi, I created a new task but it doesn't work as it should.
I have created a new task that has Type NORMAL and TrustLevel No Saftey, when I test it and try to stop the task it doesn't work, I get "Status 10085 Task Ewab_Ut can't be stopped. The trust level is set to a security level”, what could be wrong?
It is an S4c+ with 3 tasks.
Hello, I have a weld starting problem.
When the robot fails to ignite the arc, it makes a scratch start and the weld ignites and robot returns to the starting position, but there it turns off the weld, completes the end cycle off the weld and waits about 0,5 – 1 second, then it ignites the weld again and continues.
I would like it to not turn off the weld but just continue welding after returning to the start position.
It is a Yaskawa yrc1000 controller with a Fronius TPSi power source.
Thanks you for your advice
I'm in need of a manual for the ABB S4C+ system parameters.
Is it possible to have more than one Arc Auxiliary Condition file on the YRC1000 system?