Hi everyone! I have a new project which is new for me. The project requires to connect LR Mate 200iD 7L with the new controller 30iB Mate Plus with PLC of Siemens S7 1200 via ProfiNet. I have already the required GSD file and I put it in my project in TIA Portal. I will use CP1604 wide mini ProfiNet daughter board for the robot. My questions are:
What are the steps for configuration of PLC network in TIA Portal?
What is the necessary software to set up CP1604?
What are the steps for configuring the robot controller?
Do I need additional network and hardware setup software?
Thanks in advance!!!
ProfiNet Fanuc and Siemens
-
Valkov -
January 23, 2019 at 3:56 PM -
Thread is marked as Resolved.
-
-
There are two manuals: B-82864EN_04_03 and PMIO_manual_[B-82864EN@04-01].
From my experience Profinet is a bit harder to set for first time. But manuals should get you started.
-
Thank you. I already have this manuals. I hope this is enough for start the project.
-
Hello,
First of all configuration for Plus Controller is a bit different than previous R30iB.
1. check your fw version on CP1604 - has to be 2.7
2. cannot use the same GSDML as for R30iB - there is not common GSDML anymore. You have to create custom one.
3. you need TIA Professional (V14+).
4. Create new project in TIA with PC Station. Insert CP1604 module(fw2.7). Set name and IP. Select input/output area (CD). Select - Enable customization and fill necessary. Compile and export GSDML
5. Than You can use this GSDML in your TIA project with PLC. -
Thank you. I already have this manuals. I hope this is enough for start the project.
Hi!
can you give me this file? I need file "B-82864EN_04_03 and PMIO_manual_[B-82864EN@04-01]."
I'm in desperate need, my email address: ***** REMOVED BY MODERATOR **** Thanks!
-
There are two manuals: B-82864EN_04_03 and PMIO_manual_[B-82864EN@04-01].
From my experience Profinet is a bit harder to set for first time. But manuals should get you started.
Could you please send me this file? Thank you very much. mail: *** REMOVED BY MODERATOR ***