Just wondering if anyone had this problem too? After I have opened a program and touched up one or more welding points and I want to test or save the file, every time this message comes up. Failed the file save process. The only thing I can do then is to close the program (without saving) and do the work again, but very often it does the same again and again.
Panasonic Robot WG-U1400 Failed the file save process
-
Rebel81 -
February 25, 2017 at 5:49 PM -
Thread is marked as Resolved.
-
-
How much free memory space do you have?
I know in case the free memory space is critically low the program sometimes is saved and somtimes it is not, I can not explain this.
What happens if you open the program and save it as a copy (upper menu bar select file >> save as).
If the program is saved without any problem you have enough memory left and something else is going on.
Try to change a position in the copy and check whether is saves or not.
What happens when you do the same thing in another program?(try changing an aircut step).
Remark, when you run a program in test modus it is first saved and closed (together with all other opened programs) and reopened again, this explains the similarity in both cases.
Pls let me know how you are doing.
NB, which controller are you using G2 or G3? -
Hello robotwelder2, you were right. I ran out of memory space. So will delete some test programs and then try doing it again. Thanks for your fast help