We are in a bind. We just replaced an APC 820 module. But of course no one has had training on loading programs. Could someone please give me step by step. I would really appreciate it. Of course it's 2:30am thank you
APC 820 how to load programs after replacing
-
ces6347 -
June 26, 2016 at 9:38 AM -
Thread is marked as Resolved.
-
-
Call COMAU Support 1 248 368 6880
-
You can also write service.robotics@comau.com for support.
When you replace APC820 you need to retain CFlash. When you reboot with the new APC820 it will boot in minimal configuration. You need to perform a Configure/Load of the CNTRLC5G_xxxxx.C5G file in \UD\sys\cnfg followed by Configure/Save/All.