Are the parameters that are displayed on the OTF screen of the TP something I could assign to a register, or GO so that I could send the data to my PLC to be displayed on a panel view?
OTF info to panelview
-
kmcgregor -
May 7, 2015 at 2:37 PM -
Thread is marked as Resolved.
-
-
Sorry, forgot this info...
I have an arc mate 100ic, I am trying to get the weld data from a lincoln electric power wave R500.
-
So I found the answer I needed.
Weld voltage and amperage data is available in the analog inputs.
I can make simple program that maps them to a GO, then run the program as BG Logic so my voltage and amperage will be available to the operator.