Can an SRDY alarm be generated by a bad process I/O board? I have an RJ2 that is used in a welding apllication. Last week the torch shorted out and i have not been able to get this robot back into service. I have replaced the estop board and checked every fuse in the controller. Any help would be greatly appreciated.
SRDY alarm
-
phicks -
December 9, 2014 at 5:45 PM -
Thread is marked as Resolved.
-
-
just an update.. So if anyone has this happen check fuses F2-F3-and F4. It ended up being the F4 fuse. Which was causing all of my headaches. Do not rely on the little white flag to show in the window it did not for me.