I need manuals for a used YA series controller, VR016 robot, G2 pendant. I would be very much obliged if someone could send any of them to me. Thank you greatly in advance. The welding unit activates the gas solenoid, but I can't activate it, or feed wire from the pendant.
Need manuals and or advice
-
33brad66 -
May 2, 2014 at 4:24 AM -
Thread is marked as Resolved.
-
-
Im ok. The welder needs to boot up before the controller. I could still use manuals thoufh if anyone could help me out. Thanks all.
-
I hope you've found the information by now. You can request the manual from Miller Welding, https://www.millerwelds.com/service/contactus.html. George Mendex, Sr. Field Service Engineer – Miller Welding Automation promptly sent the pdf manual OM9212265E17_RISC-A_series which covers the AW & VR series robots. They are serious about customer support! It will save me many days of experimenting with commands. I've tried to post that file here but it gets blocked. Good luck!
Modify message