Can anyone tell me why my robot indexes from the a to b side and every once and a while it does not make the full sweep and alarms out. Now the problem that I have when this happens is that i need to shut down the whole system for at least thirty minutes to get the alarm to clear so that i may sweep the indexer again.
These are Fanuc RJ2 controllers in a genesis cell . Any help would be appreciated.
indexer sweep abnormal
-
phicks -
March 28, 2014 at 6:15 PM -
Thread is marked as Resolved.
-
-
I HAV THIS PROBLEM UNDER CONTROL. APPEARANTLY I HAD A SAFETY RELAY OVERHEATING AND CAUSING THE SYSTEM TO SHUTDOWN WHEN IT BECAME TOO HOT. FOR NOW I HAVE A SMALL FAN ON THIS RELAY AND IT IS RUNNING FINE. THE NEW RELAY SHOULD BE HERE LATER TOODAY