Hey guys is it possible to increase the payload of a Fanuc RJ2 Controller S420iF robot? Is so, how do you do it? We keep getting an error of excessive load. Thanks!
RJ2 Payload Increase
-
tbrewton -
June 20, 2013 at 5:30 PM -
Thread is marked as Resolved.
-
-
Is It an error or a warning? If the payload is not so high than the maximun acceptable payload you can decrease the speed and the acceleration, it work but usualy is not possible to slow down the cycle time. Are you sure than your tool payload is correct?
Inviato dal mio MotoA953 con Tapatalk 2