March 21, 2019, 04:16:44 PM
Robotforum | Industrial Robots Community

 ROBOT CALIB button problem!!!

Author Topic:  ROBOT CALIB button problem!!!  (Read 238 times)

0 Members and 1 Guest are viewing this topic.

October 14, 2018, 11:25:55 PM
Read 238 times
Offline

todm


HI~~~
Good Morning~~~

I installed an external axis turntable in front of the ES165 and I want to setup a sync setup.

But I can not find the ROBOT CALIB button to do calibration between robot and station.

I have version 3.8 of the NX100.
Why is there no button?

Today at 04:16:44 PM
Reply #1

Advertisement

Guest

October 15, 2018, 11:57:30 AM
Reply #1
Offline

95devils


Coordinated motion is not turned on.
Alcohol:  The cause and solution to all life's problems


Share via facebook Share via linkedin Share via pinterest Share via reddit Share via twitter

xx
how to insert a start button and stop button in ABB S4 robot?

Started by kennedyrsb on ABB Robot Forum

4 Replies
525 Views
Last post August 05, 2018, 02:19:59 PM
by hydra
xx
Vision grid calib frames

Started by unsaint43 on Fanuc Robot Forum

0 Replies
740 Views
Last post December 08, 2016, 12:07:47 AM
by unsaint43
xx
Calib or turn set after motor replacement?

Started by krzych on Comau Robots

1 Replies
2347 Views
Last post March 12, 2015, 12:50:33 AM
by sandrot
xx
Dead mam button - Fanuc Robot

Started by dEmIDIX on Fanuc Robot Forum

2 Replies
1108 Views
Last post October 11, 2017, 12:38:43 AM
by rafahil