December 16, 2018, 01:57:58 PM
Robotforum | Industrial Robots Community

 Need to set master job


Author Topic:  Need to set master job  (Read 340 times)

0 Members and 1 Guest are viewing this topic.

July 10, 2018, 07:46:58 PM
Read 340 times
Offline

CozyCroobie


Recently we had Fronius and Motoman come into the plant I work at to integrate their welders to a cell we have. The motoman tech that was here deleted the houskeeping job that we had and we had to put a backup in. Since then we have not been able to call the master job from the quick keys in the job menu. When I go to Job, Control Master, and select Master Job it only gives me the option to call the master job, not to set the master job. If I select to call the master job then an ERROR 2290 on the pendant stating that the master job is not specified. This is a DX200 that I am working on. Thank you in advance for any help.

Linkback: https://www.robot-forum.com/robotforum/index.php?topic=27515.0
« Last Edit: July 10, 2018, 07:53:16 PM by CozyCroobie »

Today at 01:57:58 PM
Reply #1

Advertisement

Guest

July 10, 2018, 10:11:36 PM
Reply #1
Offline

95devils


In at least Management security level, go to SETUP, go to FUNCTION ENABLE.  The top line should say MASTER JOB CHANGE.  Change this to PERMIT.  I assume the obvious has been checked such as in teach mode.
Alcohol:  The cause and solution to all life's problems


Share via facebook Share via linkedin Share via pinterest Share via reddit Share via twitter

clip
vkrc2 krc 4.1.6 cannot jog/master

Started by uberdoom on KUKA Robot Forum

18 Replies
4533 Views
Last post April 23, 2016, 01:34:21 AM
by panic mode
xx
master jobs

Started by Robcad-PDPS on Yaskawa Motoman Robot Forum

2 Replies
3064 Views
Last post November 14, 2014, 01:18:22 PM
by 95devils
xx
master counts

Started by jhon jhon on Fanuc Robot Forum

3 Replies
2895 Views
Last post January 14, 2015, 12:09:56 PM
by jhon jhon
xx
Profibus Master

Started by jobo123 on Fanuc Robot Forum

1 Replies
2276 Views
Last post August 07, 2013, 06:22:02 PM
by PatPellegrini