June 18, 2019, 03:50:03 PM
Robotforum | Industrial Robots Community

 Jet Table

normal_post Author Topic:  Jet Table  (Read 178 times)

0 Members and 1 Guest are viewing this topic.

May 17, 2019, 12:30:45 PM
Read 178 times
Offline

Noob1982


I'm using the YRC1000 controller and setting up the JET Table. If I set it up to say Call JET#(1) ENTRY=I000 IF IGU#(1)>0 It faults out for over variable limit. I thought that it shouldn't even try and call it because the condition isn't true. Any help will be appreciated.

Today at 03:50:03 PM
Reply #1

Advertisement

Guest

May 18, 2019, 11:14:19 AM
Reply #1
Offline

95devils


Not typically the way I'd write that line but that's ok.  Did you populate Jet Table number 1 with the Job Names?  What is putting a value into I000?  DIN to a B then a SET, just a SET?
Alcohol:  The cause and solution to all life's problems


Share via facebook Share via linkedin Share via pinterest Share via reddit Share via twitter

xx
automatic table

Started by Martin84 on KUKA Robot Forum

15 Replies
5139 Views
Last post September 15, 2016, 02:46:18 PM
by robot_rob
xx
Table of xyz and rx ry rz for a path...

Started by AbadRosa on Yaskawa Motoman Robot Forum

0 Replies
244 Views
Last post November 15, 2018, 01:37:04 PM
by AbadRosa
xx
PSTART from a JET table?

Started by JZiesmer on Yaskawa Motoman Robot Forum

1 Replies
1633 Views
Last post January 17, 2014, 09:30:41 PM
by 95devils
xx
Need a Turn Table

Started by mjktech on Used Robots and parts

0 Replies
365 Views
Last post December 14, 2018, 05:31:04 PM
by mjktech