January 17, 2019, 05:05:00 AM
Robotforum | Industrial Robots Community

 Intermediate bit issue......


Author Topic:  Intermediate bit issue......  (Read 178 times)

0 Members and 1 Guest are viewing this topic.

August 14, 2018, 05:49:05 AM
Read 178 times
Offline

nilpatil


While in auto cycle if we hold the robot in between while it is on arcon() instruction or on timer instruction we lose intermediate output bit ....I have made some adjustment for now in plc program but i want to know if there something we can do about it from the robot side ?   well the robot i am using is MA1440 and controller is dx200.

Linkback: https://www.robot-forum.com/robotforum/index.php?topic=27908.0
  • Like    Thanks
peace out

Today at 05:05:00 AM
Reply #1

Advertisement

Guest


Share via facebook Share via linkedin Share via pinterest Share via reddit Share via twitter

exclamation
Intermediate circuit voltage too low

Started by matyastakacs on KUKA LBR IIWA

1 Replies
1006 Views
Last post September 01, 2017, 04:08:58 AM
by matyastakacs
xx
DRIVES CONTACTOR OFF, INTERMEDIATE CIRCUIT LOADED !!!

Started by mesut9270 on KUKA Robot Forum

8 Replies
609 Views
Last post September 03, 2018, 07:14:11 PM
by mesut9270
clip
Intermediate circuit volatage too low (Kuka Iiwa)

Started by wair92 on KUKA Robot Forum

2 Replies
1493 Views
Last post January 26, 2016, 08:58:40 AM
by wair92
xx
Palletizing Motion - straight down or do you add an intermediate step?

Started by prometheus-bc on Fanuc Robot Forum

4 Replies
1442 Views
Last post January 07, 2017, 12:17:44 AM
by cobenson