January 16, 2019, 08:23:32 AM
Robotforum | Industrial Robots Community

 DX200 and SKS LSQ5 Q6 and ARC Welding


Author Topic:  DX200 and SKS LSQ5 Q6 and ARC Welding  (Read 288 times)

0 Members and 1 Guest are viewing this topic.

July 15, 2018, 05:01:55 PM
Read 288 times
Offline

Mr Goo


Hi All


Has anyone got experience with SKS.


What I would like to know is, if I set my parameters using the ARC ON or ARC OFF Command (eg. ARCOFF AC=300 AV=21.0 T=0.10) will this take precedence over the parameters set in the weld file of the SKS. I currently have a macro that calls a Weld file in the SKS.

I am having problems with the, wire burning to far back towards my tip, and I am not sure what settings I can change, and I also dont
understand the SKS BurnBack parameter completely.

Initially I was getting a wires stick problem after each weld, but I have resolved this by increasing the wire feed rate during the weld.

Does anyone know where I can get a programming manual for the SKS LSQ5, as the SKS website has no information, I am new to ROBOT ARC WELDING APPLICATIONS

Thanks...


Linkback: https://www.robot-forum.com/robotforum/index.php?topic=27569.0
« Last Edit: July 15, 2018, 05:06:22 PM by Mr Goo »

Today at 08:23:32 AM
Reply #1

Advertisement

Guest

July 15, 2018, 07:13:50 PM
Reply #1
Offline

zdravо


Do You have a analog comunication or comunication that response for Amps and Voltage to welding power source?


July 16, 2018, 06:06:57 AM
Reply #2
Offline

Mr Goo


I am using a UNI5C interface with the LSQ5 Q6


Share via facebook Share via linkedin Share via pinterest Share via reddit Share via twitter

xx
Very Strange Problem : spot welding environment, Arc welding Ladder

Started by sachincool786 on Yaskawa Motoman Robot Forum

1 Replies
1205 Views
Last post September 27, 2016, 09:58:16 AM
by potis
xx
Welding robot FA006, controller D, no welding in Repeat mode.

Started by wakoru on Kawasaki Robots

7 Replies
962 Views
Last post January 11, 2019, 02:36:21 PM
by kwakisaki
question
Welding time-out error (MDT welding machine)

Started by BB119 on Fanuc Robot Forum

1 Replies
656 Views
Last post December 04, 2017, 09:03:30 AM
by bidzej
xx
Convert XRC from Spot Welding to Arc Welding

Started by timd on Yaskawa Motoman Robot Forum

3 Replies
1344 Views
Last post November 28, 2016, 03:57:20 PM
by timd