Author Topic: Is possible write a process parameter from a folge/up/makro?  (Read 2822 times)

0 Members and 1 Guest are viewing this topic.

Offline massula

  • Global Moderator
  • Sr. Member
  • *****
  • Thank You
  • -Given: 76
  • -Receive: 59
  • Posts: 402
    • Robotistas
So, in a VKRC4, with VSS 8.2.20, is possible read the numeric value from a process parameter (PROCPAR).

But, is possible WRITE a value on it without dabbling with VW_User or regular KRL?

I mean, is possible to write a value to a process parameter  (p1, p2, etc.), using VKRL syntax or, better, writing the values inside a folge or a UP, using the instructions given by inline forms?

I've already searched through all menus, in expert mode, on editing mode, but I didn't found anything. And the documentation isn't clear.

Offline mightyduck

  • Newbie
  • *
  • Thank You
  • -Given: 3
  • -Receive: 1
  • Posts: 3
Re: Is possible write a process parameter from a folge/up/makro?
« Reply #1 on: December 22, 2016, 02:26:39 PM »
You need this for PoT (Production ohne Teil= Production without Part)?

I did it through Macro50 or in UP i define PROCPAR,, p1(E15)=.....,,  this is only example.

Offline massula

  • Global Moderator
  • Sr. Member
  • *****
  • Thank You
  • -Given: 76
  • -Receive: 59
  • Posts: 402
    • Robotistas
Re: Is possible write a process parameter from a folge/up/makro?
« Reply #2 on: December 22, 2016, 08:05:54 PM »
At that time, I want to store some cycle time measurements values, in sequence, outside the timer variables, that are overwritten every cycle.

That job is finished, but now I'm curious. Can you send me your makro, mightyduck?