All good information, thanks.
We'll go the safe route and enter the information manually.
All good information, thanks.
We'll go the safe route and enter the information manually.
Good point about restoring the mastering file of the new robot after restoring the image of existing robot—noted for future reference.
I don't know if this new machine is an exact clone of the previous machine. (I'm also new here.) It might be possible to determine whether it is an exact clone, but at this point it's probably easier to enter the Config settings manually than start over.
I have already loaded the backup files for numerical registers, position registers, digital IO, and some other file names that I recognize. In the past, I've always entered the System/Config settings manually, according to a set protocol for interface with the PLC. The protocol for this application is not the same, and (as it happens) it would be better to load that protocol from the backup than to rely on memory.
Is there a backup file that is known to contain the System/Config parameters?
I have a new robot, and a backup from an existing robot in the field. I need to make the System/Config on the new robot the same as the System/Config on the existing robot. Is there a file (or files) in the backup that I can load to make this happen? (LR Mate 200 iD)