Posts by Darvel

lemster68 will you have the boot disks? for IRB 2400L M98 or Do you know who can help me?

hi Makara Did you solve your problem? i have the same problem i haven´t boot and key disks.

Trebert7. Hi Could you explain me how you did it?

Quote from pb5024

Thanks! Surely, I will keep an eye on the board model and its compatibility. As for the repair option: I am exploring it as well, I was just working on some project in parallel, and I haven't looked quite well at it. Do you happened to know any company of that specialty? I am quite new to the subject (robotics and ABB units in particular), and I still have a lot to learn. I need to say: reading messages on this forum helped me a lot!

Regarding the error I am getting: it does not look like an error; as I am trying to do the initial software installation after a cold start, it is gets interrupted at a certain point; it goes like this: (1) key disk; (2) disk 1; (3) disk 4; (4) disk 5, and then it restarts and gets back to that “insert key disk” prompt. It looks like it restarts for no reason in the middle of the installation. I have tried it several times, and the result was same every time. I ruled out the corrupted disk(s) option, since I've received a new set from ABB recently.

Initially this controller also had a bad memory board (it could not get past a memory test in the cold start sequence, code 2002), but I replaced it. After that I discovered this problem with installation. After some digging I found out that the flash memory can get corrupted by a wrong software version. I don't know the history of this unit but we have another robot with BW 3.2, so it is quite possible that someone in the past tried installing a wrong version of the software.

Could you send me all disk?. I´ve been looking for them and i can´t find them.

Quote from jason_alex_2009

I have done a c-start a few times and have sucessfully installed the boot disk or base ware my problem now is trying to control the welding settings such as dowirefeed dogas exc trying to figure out what other software i need to install and how i need to install and configure it. I have a bunch of files that i have been told need to be boot installed rather than loaded such as the pib files with files dose it need it is a miller power supply with a miller wire feeder.

could you sendme the key disk and all disk (1-10) please. I would appreciate a lot

e-mail: darvel_y_23@hotmail.com

Hi i need the key disk an all disk for install S4C controller