how do you delete a line in a fanuc arc mate 100. For some reason I have 6 wait lines. Never had them before thanks
Posts by ktmark
-
-
this robot was working great for the last couple years worked fine yesterday and a little today, when it starts to weld it stops or just feeds the wire and skips to the next one to weld and does about the same. some times it pops or arcs.. i checked the ground wires look ok. Erratic wire feeding or welding any ideas thanks -
Thanks. I will check this all out Tuesday! I appreciate you alls help
-
well the robot. Guy put a password in. But. I was told he got rid of it somehow because he couldn't remember it. Okay how do u know or can tell that it is on quick menu thanks
-
thanks Hawkme. But when I press menu system. Is not in the list (
-
I am not able to get to that screen any help would be greatly appreciated..
-
I have a similar problem. Got a servo bzal o62 alarm but can not get to the screen to clear alarm. I replaced all the batteries. What am I missing. ? Here is a snap shot of what is on the screen r j 3 controller
Images
-
I have a similar problem. Got a servo bzal o62 alarm but can not get to the screen to clear alarm. I replaced all the batteries. What am I missing. ? Here is a snap shot of what is on the screen
-
-
hi. Scooter. I did have the robot on when changing the batteries . Also. I had to change batteries in. Another robot fanuc. And the alarm bzal was still there on that one then ken the robot tech said it was missing the master/ cal. He showed me to re enter it and then the alarm went off but still had to be calibrated. .
Probably need to do ot to this one what woyld be the procedure to master calibrate it ? Thanks
-
-
okay. I will try that and let you know thanks
-
-
-
-
-
-
-
I have a fanuc Robot 100 that is stuck on controlled start. The person left it like this. So. How do I get passed this to. Get the robot functional it is an rj3
-