well we got it fixed those wait lines where for the proxy to be engaged before starting. There was a line above home that caused the robot to function differently. Got it done thanks
Posts by ktmark
-
-
I did that what is going on is this robot moves to the left but suppose to move to the right it had 6 wait lines in it never had that before when we press the cycle start for the right side it moves to the left about a half turn then comes over to the right side and runs. But it takes too long. I deleted the wait lines but it didn't fix the problem
-
how do you delete a line in a fanuc arc mate 100. For some reason I have 6 wait lines. Never had them before thanks
-
this robot was working great for the last couple years worked fine yesterday and a little today, when it starts to weld it stops or just feeds the wire and skips to the next one to weld and does about the same. some times it pops or arcs.. i checked the ground wires look ok. Erratic wire feeding or welding any ideas thanks -
Thanks. I will check this all out Tuesday! I appreciate you alls help
-
well the robot. Guy put a password in. But. I was told he got rid of it somehow because he couldn't remember it. Okay how do u know or can tell that it is on quick menu thanks
-
thanks Hawkme. But when I press menu system. Is not in the list (
-
I am not able to get to that screen any help would be greatly appreciated..
-
I have a similar problem. Got a servo bzal o62 alarm but can not get to the screen to clear alarm. I replaced all the batteries. What am I missing. ? Here is a snap shot of what is on the screen r j 3 controller
Images
-
I have a similar problem. Got a servo bzal o62 alarm but can not get to the screen to clear alarm. I replaced all the batteries. What am I missing. ? Here is a snap shot of what is on the screen
-
-
hi. Scooter. I did have the robot on when changing the batteries . Also. I had to change batteries in. Another robot fanuc. And the alarm bzal was still there on that one then ken the robot tech said it was missing the master/ cal. He showed me to re enter it and then the alarm went off but still had to be calibrated. .
Probably need to do ot to this one what woyld be the procedure to master calibrate it ? Thanks
-
-
okay. I will try that and let you know thanks
-
-
-
-
-
-