Posts by ktmark
-
-
-
Well sirs we finally got this to work was able to get past the old password and created a new one getting ready to master it. Thanks again for all your input 👍 😊
-
No sir I didn't take a picture I will and send it here
-
Well we tried to back up the image file on the boot menu it only has restore/ backup. Not just backup . So when you loaded it i. Notebook i couldn't find the file that contains the password. Am I doing this wrong. Thanks for any help in advice ...
-
We have a rj3 machine do not have those additional. Also when we are in the screen we do no have disable but cler and clear all only
-
Oh we don't have access utilities and setup
-
What part of the interface screen do we need to take a picture of. Thanks very helpful
-
Thank you sir. Yes these are online amazon batteries they say oem . Also there is 3 levels for password one installer an 2 for setup and third operator . The password that we are having problems with us the installer he doesn't remember the password it's been 5 yrs since he left and that's where we are at so far now fanuc said the need a authorized person to okay them to give us a code . But we haven't tried that yet. Thanks again not sure if they will or not trying to go pass that with your help from these posts thanks .
-
Hi sirs. I have a tech helper trying to eliminate the bzal 062 fault we changed the 4 batteries n top of the arm. It's an arcmate 50ic robot. And also changed the battery in the controller while it was on. Yet he reset the fault but will not go away still shows that fault. Also we did a controlled start trying to by pass the password he couldn't do anything without out the original pass word can fanuc provide a override password. Need assistance on this thanks in advance . Also. Trying g to do a back up. But I believe the password is preventing us .to do that .. we were in the maintance mode but still would not allow us to go further without the password. Thanks again.
-
-
@ kawakisaki okay thanks sorry about the multiple posts .
-
.
What i have is a rj3 robot arcmate that is password protected . The guy is no longer here and we cannot get past the password to program the robot also we have no back up software . How can we by pass the password thanks. Sir
-
Right now there are novpulse code error 061 0r 075 they have nor come up. But will check the zero position points as you stated thank you sir .. yes this is arc welding on both robots
-
loose
Well right now we are thinking encoders are bad but thst would mean remastering not sure of the cost , could it be that . When we run a program on one side get it touched up then run the other side even after just a day we run the other side it seems the points are off just allittle mainly up higher or farther away . Actually we have 2 robots that are doing this ..this one an another one same model . The other robot same model. Doesn't have this issue thanks sir .
-
My arcmate robot is an issue rj2 controller. It will not keep our points after a day of running . We have to touch it up each day any reasons why. Thanks sir .
-
Thank you. We have the angle at about 45degrees and about a 1/2inch stick out trim is at 22 and speed at 320 any suggestions thanks again
-
Hi. I just was wondering we are needing more pentatration what is best using thr trim of was. I have a pulse Lincoln welder on a fanuc arcmate 100i welding robot . Thanks
-
Well want to give an update. On this thread it is fixed I didn't lose the program lines what happened was it didn't have the call B side for that program . We added it and now it works. Great 👍
-
Oh I have an rj3 controller. Not the new one that is shown on the video. Need to know how to navigate with thst one thanks .
Advertising from our partners
