also ,i will try to repair my cpu board,please Can send me cpu firmware ?
Posts by CGBS
-
-
I'm based in Martinica
i have check again all controller harnness board ( disconnect ,clean and reconnect ) and power on ,but i have the same problem.
i try to buy cpu board this week
my cpu board # is 50999-1854R10
Let me know if i can try cpu board # 50999-2383R24
i can sea the similar cpu picture
-
j'ai acheter en Belgique
-
Ok merci pour vos informations interbus
je dois faire ça, mais j'ai toujours l'écran blanc
-
ok i Will do this ,
But about the interbus board what the controller Can do with this ?
-
yes i 'm agree with you.
Now i have always the same problem.
I Will try to reflash the cpu board with my cpu programming tool, but i need software backup
Cou you send me this ?
-
dear kwakisaki
C'est la procédure que vous avez donné lors cette discussion.
-
MFP screen after initiatialisation
and white screen after last initialisation
-
this is the mfp screen fisrt power on
-
OK KAWAKISAKI
I will check again all and back to you
Thanks
-
fist time
i have power on the controller , mfp show me : ac power motor off with keyboard
next i have put the DP 1 and 8 to on and power on the controller and try the procedure 1 initialisation , backt to dip 1 on 8 off power on ,every is going good but the robot don't moove
i try to moove the robot by TB2 jump , ROBOT NO MOOVE
i try to initialise again the controller with procedure 1 and 2 (with forget to backup as/sv the file ) .
Now i have MFP white screen
-
NO ,i have buy a good controller, i have just try to moove the robot
i have this problem when i have finish the reinitialisation and power off and power on the controller
is very stange
-
ok i will try to find this spares
do you know where can i find this ?
-
this is really strange the cpu will be faulty after reinitialisation only ,
-
all the 4 1HP board led is good
-
i have :
4.96 v
11.96 v
-11.96 v
-
let me know if this test ring i show you ?
-
WHAT IS DVM ?
whAT IS AVR ?
-
let me know if i can use the 1GA / 1HA LAN connexion ?
-
i have do
but no rs232 communication