Posts by Shane100Irish

Thank you for the info.

I had opened the pendant to investigate, attached are the internal Enabling switches.

Jokab safety switch

JSHD 2B

Has anyone got a good source For replacement?

Thank you

Can you purchase the dead man switch for the teach pendant?

Current Teach pendant switch is sticking

S4C Teach Pendant.

A Guide to add the DSQC 328 I/O Card & Declare User I/O on the S4C system

Thank you Makara

Would anyone have a key disk for IRB6400 S4C with the 536 NFS option enabled

Example as below

3HAC2642-1/02 System Key S4C 3.0

Serial no 64-00000

Included options:

512 BaseWare OS Plus

575 English

No Ext Axes

6400/2.4-150

806 Battery Supervision

530 Advanced Functions

532 Multitasking

537 Developer Functions

534 FactoryWare interface

536 Ethernet Services

Attached M97 Back info txt file

Attached RW3.2 and Key Disk

Insert Boot Disk 1

It is probably looking for the Key Disk at 01st , Then once it has read this (Usually in a couple of seconds) - Insert Boot Disk 1 and press any key

Are you looking for a back up or key disk for an S4C or an S4C+ ?

I will look through some archive data, Can you send PM with email contact

Thanks Skooter

What is the best way to install it?

Do you still require winolpc?

Hi All,

Would anybody have either of the options below for RW3.0 S4C?

Opt. 543/128-1 Ethernet Services FTP part no 3HAC034439-001

Opt. 536/128-1 Ethernet Services NFS part no 3HAC034440-001

Thank you

Shane

Hello Kbekkala,

Did you have success in fixing this issue?

I am finding the same issue.

I have an IRB6400 m97a S4C systemBaseWare 3.0.

My position files may also have 200,000 points

If you found a solution could you share?

Thank you

Hi Rainman, Hi Skooter,

Thank you for your advice

I will begin to work with these parameters.

Has anyone used the ABB 3HAC041840-001 S4 S4C, S4C+ Robot Controller Floppy Drive to USB Kit?

Would you recommend?

Thank you

Hi SAABoholic,

Thanks for your reply.

My Robots have the ethernet board installed

I have win 10 PC with services for NFS enabled which is connected to a netgear switch and I can connect the robot to this also,

How do I connect between PC & Robot for example is there a similar command as connecting to another PC - \\192.168.x.x\c$

Thanks.

Dear All,

Does anybody have a guide how to set up FTP to IRB6400 M97A controller?

I would like to be able to transfer programs from the PC to the M97A controller

Thank you

Hi Skooter,

I am starting from scratch.

Appreciate if you have some tips.

Thank you

Shane

Dear All,

Robot Status -> Software Re-Install after Cold start

DSQC 328 I/O Boards configured (MS/NS lights flashing correctly)

How do I map the I/O on the DSQC 328 I/O board

Thank you

I Have 2 Fanuc S420F RG2

1 is working well - The other will work with a little effort

Check the link below

Send a PM if your interested

Dear All,

Would anyone have a wiring diagram for ABB quick release heads ABB flexible automation T&C
3HXB 0100-39
3HXB 0100-67

Thank you