Posts by Majid Hd

We are planning to buy MFC2 board with model 00-108-766, but the suppliers have suggested me to buy model00- 123-879. Is this card the right replacement in our current system? And does it work without problems or not? By the way, our controller type is KR C2 and MP1 type.

dear Panic,

Yes, you wrote the correct format of the article. My question is, is it possible to use 00-123-879 instead of 00-108-766?

Apparently the suppliers are unable to supply 00-108-766.

We are planning to buy MFC2 board with model 00-108-766, but the suppliers have suggested me to buy model00- 123-879. Is this card the right replacement in our current system? And does it work without problems or not? By the way, our controller type is KR C2 and MP1 type.

Thank you TSGIR for your response, I saw somewhere that by changing the S2C parameters, the access level can be changed or reset. Can you help in this regard?

Dear sir ,

I bought a second-hand robot with nx100 controller that is only active up to the editing level and the seller has disabled access to a higher level. How can I enable access or return to the default passwords of Yaskawa company?

Dear eeleker, Was your problem solved?

Dear Silverstamp;

Was your problem solved?

Hii

After four years of operation without any problems, my robot suddenly started giving error 4328 and two minutes later it gave error 4315. After inspection and amperation, the robot was launched again, but the same errors occurred again after working for an hour. All cards and cables were checked and finally the problem was solved by replacing the S Axis (SGMRV 37ANA) servo motor.

I asked a few people about this and they complain about Break Servo. I also checked the resistance value of the break coil, but it was correct and within the allowable range. Do you know what is wrong with the engine mechanism to prevent these faults from recurring or to repair the service?

Hello dear experts

Can any of you help me repair the SGMRV 37ANA series servo motor? I have a problem removing the brakes.Is there no special MANUAL for servo motor brake repair?

Excuse me, did you work with motoman robots?

I have function files. How to install on pendant?

Dear sir

I need the manual of these KSD, Do u have?

Dear TSGIR ,

Thanks for Reply ,Due to the sudden leakage of grease from this hole.This hole and box has become important for my work.

Dear Freiends ,

I have Yaskawa Motoman MPX3500 ,I had a few questions,Please Answer my Questions Below.

1)What is the purpose of the hole under the S- gearbox ?

2)What is the purpose of the Red Box in Bottom of S -Base?. This is just an empty box connected by a hose under the S Axis gearbox. A closed valve is also in the way (Attached pic).

Best Requard