hello
I am looking for the reference of a devicenet cable for the x801 port
Thanks
hello
I am looking for the reference of a devicenet cable for the x801 port
Thanks
Hello ,
I would like to wired a door striker, an emergency stop and 2 rotary key (for the selection of automatic and manual).
On a krc2 Do.
I have to wire all to a safety relay for so little equipment?
If so, which x11 terminal block I can wire them to.
Thanks
it's good I found
To find out if the robot is at a standstill, it is enough not to have the ignition on on x11
thanks your heelp me
so if i cant use an one output on x11. I will have to add a card again?
Because on the cabinet I only have this x11 output for cabled with peripherals.
Hello, I have for project the implantation of a robot kuka krc2
The problem is that I only have the x11 party on the cabinet which can provide me with outputs. But is there an output in these outputs that indicates when the robot is at a standstill?
So that I can use it for a PLC input
Thank you
sorry ,
Is there a protocol to follow for power supply?
Hello I have to put my robot back on when the bay has been moved for 1 year Is there a protocol to follow for its release under tention? a krc15 with a krc2 .
great, thank you
I will do my calculations of my intensity
yes I have the doc with all the connectors for x11
But if I connect my control cabinet to this 24v output and I plug in as equipment that will be connected to the 24v power supply: -4 button with 1 light -a magnetic door closure -an automat - 2 security keys for robotics
Is it possible with all this equipment to connect it to the 24v of the krc2?
Thank you for your documents and your help.
So for my case a power supply of my control cabinet with 24v x11 would be possible?
And for the monitoring of the e-stop it is used to know when the robot is stopped?
So can it be used to open a door?
Great thanks, I see but if the 24 v only supplies an automaton of indicator lights of the griphare type and indicator light of button.
Would that be possible?
If it is possible what should I do to avoid burning some component of krc2?
Hello
I would have liked to have information on the harting x11 port of a krc2 from kuka.
Is it possible in a control cabinet to bring in the 24v from the robotic bay to supply the electrical components that are found?
In the harting x11 socket, is there an output that signals the robot stop?
thank you for any help provided