Hello kurtk,
the fix was to re-install the kuka software.
I got the installer and procedure from my kuka tech support contact, he will need the robot serial.
Then I accessed the robot´s windows desktop, and installed it like any windows app.
Hello kurtk,
the fix was to re-install the kuka software.
I got the installer and procedure from my kuka tech support contact, he will need the robot serial.
Then I accessed the robot´s windows desktop, and installed it like any windows app.
I used the backup menu to create a backup to the USB pen, opened it in workvisual on my laptop, configured IO, and then restore it on the robot controller.
The original files I was refering to are .asz and WOV project files, and a ZIP file with C, KRC folders.
I have copied the .src and .dat files that I want to keep to my laptop.
I did not change any XML, I only know the KSS uses them from having to configure KUKA.Ethernet KRL on a different robot.
Hello Panic mode,
I did not create a project from scratch, i just wanted to configure IO.
I didnt have a ethernet cable on hand, so i used a USB pen, and something went wrong.
I still have the original files on the pen, its pretty much factory state. The KRL programming is saved on PC.
I have experience programing KRL, and level 2 training.
I have a basic understanding of XML, but I never configured a robot controler at that level.
Hello robot-forum,
I have a KR C4, KSS8.6.6 controller that seems stuck on a invalid project config, several menus dont open with a message of inicialization error, like backup configuration, safety configuration.
Machine configuration says no project is active.
There is a red cross over the projects icon.
When i try to activate a project, either the inital project or a new from workvisual(V6.0.12), an error is thrown:
QuoteAn error occurred during activation.
Project not ready! Controller: <PCRC-3LW89UTRSO(localhost)>
QuoteWhen i try to restore to a restore point, its the following error:
An error occurred during restoration.
Unknown error during project activation of restored project 26110802...
In both cases the first message on the message list is that it failed to create a restore point.
I suspect the backup fails because the controller is in an invallid state, but i cant fix it because it tries to create a backup before a project is activated.
Can I deactivate the automatic restore point creation?
Any other possible causes?