Posts by hublew31

Right... Do you know which parameter has to be edited? I am trying to find a list of parameters for DX100, but no success so far.

Here is a video of me trying to do everything you told me to do.

Yes Im in teach, when i press select nothing happens. So I cant even put the instruction in the ladder program

I’ve looked into the Concurrent I/O manual and tried to insert instruction but it won’t let me do anythig in ladder program. I am in management mode and user ladder...

Ok, thank you:))

Where do I do the:

«STR#80026

OUT#30050»

?

Hello. Is it possible to connect E-stop signal from TP to an external system/controlling device? All im looking for is 24V signal from Estop.

Yes to all of them.

On page 339 and 340 you can find information on transmission parameters. Check if those are correct. It might solve the issue.

I might have found an answer to my question. This is what I found in FS100 maintence manual. I'm not sure if this converts to NX/DX etc. but I hope it might help some of you.

(1)Reset the alarm.
(2)If the alarm occurs again, send EOT code to release the data link and then
check that the sending side data is correctly set.
(3)Check that the communication setting is correct.

Hello everyone!

Lately I've been having this problem while saving and loading different jobs, by using SAVEJ and LOADJ. The robot takes forever to load the job and when a minute or two have passed "Alarm 4105 [222]" pops up. I have already tried replacing the communication cable between the PC and robot with a new one, unfortunately nothing has changed.

Have you delt with this problem before?

Thank you for your help and time.

Here is a picture of the line where it usually stops.

Hi Everyone!

I'm having a problem with my NX100. Sometimes while loading and saving variables using SAVEV and LOADV the robot stops and Alarm code 4105 [235] pops up. This has been happening for a while now. The robot is using a camera for detection of products, and it's wirelessly connected to a PC where Scorpion Vision is running. When the product can't be found by Scorpion Vision and the program has been repeated a couple of times this message pops up. We have been just reseting it throughout the years but it is getting a little bit annoying after a while. Does anyone know what can be the cause to this problem? In advance, thank you for your reply.