OK!! Thank you very much for your help and SORRY to not post in the correct place
very thankful
OK!! Thank you very much for your help and SORRY to not post in the correct place
very thankful
i only have ux 150 control C sofware
could i install it in the ux-120 ?
thanks !!
i only have ux 150 control C sofware
could i install it in the ux-150 ?
thanks !!
becouse i have in the company a lot of ux -150... and i would like that this ux -120 install the same software thant ux 150 , to share mft, cards etc... in case i need it
ux 120
control C 42F-A001
SORRRY... both of them are c control
hello Good afefternoon everybody
I am triying to back to life a ux 120 and i have any doubts.....
ux 120 contro C and ux 150 control c is the same robot? only change the software? Could i Install an ux 150 control c software in an ux 120?
A lot of questions.....Thanks in advance!!!
The robot works ok no issues
thanks!!!
Hello , I solved the problem .
I could doownload a european version. tp software, servo software and as software and is ok
Thanks a lot
ok . THANK YOU VERY MUCH
Thanks for your answere , becouse i need to change the teach pendant and download the tp firmware version......
GOOD Moornig everybody!
I need a litle bit of help
i need to download this c software version 23010KAE..... Have anybody this version?
THANKS IN ADVANCE
Thank you very much
could I send you a back up?
THANKS .THE FIRST THING I MADE WAS reinitialitale to factory setting.
i am investigating but i can not acces to a maintenance adjust
in the C control if you put xxxxxx you can see a lot of opcions...
do you know how can i see this options in the D control?
Thank you very much for your answer.
I will continuos investigate it and i will coment .....
As i told you i bought the robot used and is the firts day i start the produccion
could be a problem with any CARD?
thank you
Thank you very much for your answer.
I will continuos investigate it and i will coment .....
As i told you i bought the robot used and is the firts day i start the produccion
could be a problem with any target?
thank you
GOOD afternoom!
I have just installed a used kawaski fs 30 L control D.
I have this problem. I am producing during 2 o 3 hours and suddenly robot stop with the mesaage errror e0001 unknow. the robot does not rec ognize any command . I turn off and on again the control and continuos working but 2 o 3 hours later again the same problem.....
Anybody can help me please??
thanks in advance
oscar
Thanks to you for your help!!
If i exchange the original 1hp
error 1338 k1 or k2 work wrong
may be we had two differents problems ............
Finally I solved the problem, but i had to change the 1hp card and 1ga card.......
now is running
thank you very much!!!!