Posts by paulfile

Hello

This is the first time something like this happens to me.the card is broken and I have to do it.But the resin is applied.

I used alcohol, thinner, chemical cleaner, ultrosonic cleaner but didn't work.

Has anyone happened to you before?

sdf

I notified the Fronius source with Kuka. But I have a problem. I can only work in one job (program no). I have defined more than one job on the source machine. When I start a program, Kuka is always welding on job1. I want to use job1, job2, job3 in one program. I want to switch from job1 to job2 in the program. how can I do that.

Hello friends

i am newbie in roboguide.The pats in the picture appears when the robot is operating in automatic mode.I want it not to appear.

I checked the manual, are you talking about here?

While backing up the image, we encountered the problem of "failed, file not restored". The path we followed during the restore and the message we received, I don't know if the problem is with the restore or the image backup file.

I want to make a choice after using waittimeout . If yes, the robot will continue and if it marks no, the robot will go to home position.

I contacted Fanuc.Fanuc said she gave it for free.I SUBMITTED THE AOA BACKUP FILE AND THEY SENT ME THE İMAGE FILE.

Is it necessary to pay a fee to install?

I do not fully understand. Will I do this from this part?

Hello

I haven't worked too much with fanuc robots.I know how to use other robots and I am new to fanuc robot.When a condition is met, if your example is if (di1=1 and di2=1), I want to stop the robot's motion and I want to make a selection with a written text."Are you sure you can start the robot?"I want the sub-media to have two choices.If I check yes the robot will continue to run.If I tick no, the robot won't move.i did this with abb irc5.how can i do the same with fanuc.I need your comments

I thank everyone and wish you good work.

THANK YOUU

hello everyone friends, good luck

I'm doing a work with Fanuc R30ib system.I am using uop signals.I don't know where ACK1 / SNO1 is used.Can I assign system signals to these signals?Or are they just used as system signals as in the picture?I want to get the cycle start (motor on) signal as an output. How should I do this?

thank you

used for mate cabinet.Can I use a type inside a cabinet?

hello, good work everyone

I need to work with the fanuc mate cabin.Then I have to work with a cabinets.For this I need to learn the difference between crma 15-16 and crma 58-59.I know crma 58-59 is used in mate cabinet, but I'm not sure.I have no idea for a cabinet.Does anyone know the difference between them? (crma 15-16 and crma 58-59)

Thank you very much!

Hello everyone, good work

I have not worked with fanuc robots before.I want to use a system output signal or a system input signal as a digital output signal.For example, I want to start the system with a button from outside.I want to receive a system error signal as a digital output.I need your help in this matter.

(For A cabinet and mate cabinet)

You guys are great.You have been very helpful and saved me

"!" I found out it is the or operator.

thank you