Posts by Enio

I need to do domethingh similar to Bullseye subprogram, only executable not editable

thanks Lester,I will try that, anyway is possible to make a subprogram not editable without a password? Is there any way

Hello everyone, I am trying to figure out how to make my subprograms not modificabile or not visible in manual execution , does anyone have any idea?Thanks in abvance

It is a 1500 I think

Hello Robopal I have checked the motor cables for continuity and in axes 1 and 2 Ispot something wire, two pins on both motors are in contact with one another exactly the F and E pin in both motors ,is that normal ?

no red lights on drive boards

Ok thanks ,

Thanks Skooter , can you tell me the the path for setting load of the wrist,

Thank Skooter , we have try I-start in quiry mode and select Dc4 problem solved, but don't understand why loading with robinstall in silent mode doesn't recognize DSQC 358

hello everyone, we are dealing with an old S3 M93 .We are trying to revive it . Have load parameters from prom and as soon as the Robot moves , give an motor overload foult, checked the error list and it says only initialize the robot, enyone have any idea what could be the issue, thanks

Hello guys, I have an error code refering to Dc-link type ( 38300 )in a S4C+ M2000 , does anyone know what it means ,attach photo ,thanks

thanks Skooter

Hello everyone, is there anyone who can share the S4C+ M2000 irb1400 error code

Thanks

Hello Skooter, it the only way to bypass the SMB located in the cabinet , I think it has some foult and is not allowing me to run the manipulator without external axes,is there something else i can do?

Hello everyone, is there anyone who knows how to test an SMB if it is working or not ,

Thanks

Hello everyone , we have a S3 M93 welder robot, we having some troble with the external axes, we start the robot from prom, is possible to cut out the SMB for external axes located in the cabinet? I see it is connected in series with the one in the manipulator. Thanks in advance guys

I was wandering do I need to put the robot in sync position ,I haven't done that as long as it can't move with jogging .

Hello Skooter, yes of course, I have pressed activate after done all 6 axes and nothing is changed after reboot .

Thanks Skooter,

As always very helpful 😁

Hello everyone,

We're having troubles revives an old S3M92 welder with external axes,we have replaced the main computer taken from a twin robot . Actually we have load parameters from prom and set sincoff offsets but we haven't been able to change the comoff value, does anyone tell us why and how we can set the sincoff original values of the Robot.

Thanks in advance guys