ok ,but how to do to release brakes,?
Posts by Enio
-
-
so I need to disconect that conection?,there is one more conection in the box labeled BUS
-
-
hello, i mean motor off state
-
hello, i am having troble with an Irc5 with Irbp250R type positioner, is there any way to move manualy the interchange when the robot is in standby, any way to relese the brakes?
Thanks folks
-
Hello, I am dealing with an old S3 M93 irb1400 welder with two table interchange external axes. is there anyway that I can use the table one program even in the second station,
anyone have any idea how to do it ,Thanks folks
-
hello everyone,I wont to try to run check TCP in auto mode ,is it possible ,dit it update the TCP value ? my idea is to run it every 10 cycles ,can someone help me with this thing,
thanks in advance Folks,
I forgot to mention that the robot is a M98 weder with irbp positioner
-
Thanks Skooter, problem solved.
Very helpful as always.
-
Hello everybody , we have problems with a S4C M98 ,sudently it goes off and does not turn on anymore ,the power is present on the main switch it seems ok. Does anyone know what's going on ? Thanks guys
-
Thanks Robiman
-
Hello again , does anyone have the electrical diagram for the Run Chain, S4C+ M2000
I think it will help ,
Thanks
-
Skooter i have no other teachpedant to try but I measure the function of two switches and it seams they are fine.it is possible that teachpedant cable is bad ,is there any way to determine which pins of conector corisponde to deadman switches
-
Hello Skooter,all the LEDs on DSQC 509 are lit even when i pull the Deadman or not, Uploaded the two errors which it gives
robot-forum.com/attachment/30851/
-
Sorry Her mann, I forgot to mention that I press the deadman on the Teach pedant.
Skooter I don't know about the LEDs wen switch the deadman, in wich boar are located.If I understood well the LEDs should go on wen I switch the deadman?
-
Hello everyone.
We have an issue with a S4C+ controller 1400 welder .It works fine in automatic mode ,but when we change in manual mode the motors doesn't go on. It seems like a contractor is bad.
Does anyone know what's going on
Thanks in advance
-
Thanks a lot my friend.
I fill it with 1.5 l ABB gear oil and now is working fine.
-
Hello everyone,
We need help with an Irb 1400 .
We have replaced the axes 3 motor due to bad O ring .Can someone tell us what's the gear oil level indicator.
Thanks in advance
-
Hello Skooter,the error code showing me is 598 error current drive unit 7.than 536 run chain enable 21,506 servo error 2, it seam we are close to make it work
-
Hello everyone, finally we have been able to revive an old S3 M93 welder with external axes two station.The issue we have now is that the station didn't stay fixet when we execute the working program and goes in servo 2 error, the brakes are ok as long as wen turn of the robot the station doesn't move ,it seam some output stey high ,does anyone have any idea what could be the issue,thanks in advance guys
-
Hello Lemster , i have put the routin I am a sysmodul and asign a variable but i did not be able to make it Noview ,i have an S4C M98 how can i do the modul non visible