Hello guys, I have a problem with an M99 S4 welder, it does not inhibit the weldin, I need to figure out whats going on,is anybody have any idea whats going on and how to overpass this. Thanks
Posts by Enio
-
-
Hello skooter ,i am not sure about the manipulator maby is a irb1500
here is a photo
-
Hello everyone, we have trouble with an old S3 M93 irb1400 welder.The robot stop to many times at arc start,the wire seams burn at the tip.Is there any parameter to fix that? Is possible to put a retry option on this robot?
Thanks
-
-
-
-
hello ,cN you show a photo,standing what you say, after release the emergency stop, you need to hold the motor on button and push the deadman on the tech pedant ,keeping pushed the motor on button
-
Hello guys , I have problems with an IRC5 ,IRBP R-Type positiner.It showes me en error related to the interch. unit activation reley .Can enyone tell me where are located inthe cabinet the unit activation reley.Thanks Guys
-
Did enyone have the circuit diagram for the station activation ?
-
Hello evreryone , I am having problems with a IRC5 with IRBP R type positiner. Wen I try to change stations the activation contactor goes off showing me the error like the photo down here. I have removed the limit switches ,I am not sure if I replaced the right way, did anyone tell me whtas going on.
thanks
-
Good question Robiman, the interchange is making a loud noise wen it turns ,relesing the brakes is isyer to determ if is the bearing or the gear reducer,what you think?
-
ok will try with the bateries,
thanks alot my friend,very helpfull
-
yes ,is too risky, do you have any idea from when I can take 24 V in a safety way from inside the cabinet ?0
-
can i take 24 V somewhere from the controller?
-
do you have any idea from where to bring 24 V to the nr 3 conection and 0 ?
-
interchange unit
-
OK, I find the electric diagram , find the motor power conection and brake conection, how do I procede
-
thanks , I have already dowloaded it , what should I search for in this manual
-
I think the motor cable goes to the K5 contactor
-
unfortunely no , what should I need to find maby i can do it without the diagram