Hello all.
In FANUC Robot Spot welding Program why weld(spot) position(POS) is required in CARTESIAN(x,y,z) type. If the weld POS was in JOINT type then robot will gives the alarm SVGN-028 POS TYPE IS JOINT.
Any interlock or other reason behind this.
Posts by Mohammad Gouse
-
-
Okay thanks for quick response.
-
Hello i am having an issue in Fanuc R30ia controller with R2000IB 165F.i had done wing to EE-K165 connector to my gripper where i am receiving 24vdc and 0vdc from robot.
But when i tried to on R01-R06 there is no 24vdc coming from robot. Same as i tried by giving 24vdc to RI1 its not showing the input in robot teach pendent.
what would be the problem and what is the use of AS-166 Connector.
can i get any help?
-
Hello i am having an issue in Fanuc R30ia controller with R2000IB 165F.i had done wing to EE-K165 connector to my gripper where i am receiving 24vdc and 0vdc from robot.
But when i tried to on R01-R06 there is no 24vdc coming from robot. Same as i tried by giving 24vdc to RI1 its not showing the input in robot teach pendent.
what would be the problem and what is the use of AS-166 Connector.
can i get any help?
-
Hello does anyone know how to disable group2 and group3 in fanuc robot where external axis are deleted earlier.
-
Hello This Is Mohammad
I'm Having An Arc Mate 100ic Robot In My Fanuc RoboGuide.I Want To Add An External Axis(Ac Servo Motor MODEL:-Alphs iS/ 12/4000B) To Rotate My Welding Fixture.
Which Motor I Have To Choose.
Thanks In Advance..
-
That's A Great Response From You🙏.
I Want To Add An External Axis (Servo Motor)To Rotating My Welding Fixture.Is The Procedure Is Same As Above?