Thank you - I will contact them and see if they can help
Posts by piotrbu1
-
-
Helo.
I have tried the COLD, then CTRL, then INIT start. There is a message "No system software". Today I have loaded the system backup from other robot - iF version to test if the robot is functional. Everything works, but the robot will not travel in a straight line. I think the iW has different reducers than iF and the image from iF will not work. Or is there a way to change the motor and geometry parameters of the installed system (I think not possible) ?
Unfortunately for the work we do (welding big, thick 10mm parts) we need the Arc Tool with weave option. I think it will be cheaper to buy a new robot than get the new system software from Fanuc
-
Helo.
We have a big problem with one of our old arc welding robots. Everything was working fine, until yesterday after a power outage we have no system software on the robot After power on, we have only the boot monitor screen as in the photo. Unfortunately we do not have the original system installation disks and the old CD with controller backup is not working (we have tried in a couple of different computers
We have only this one iW version, our other robots are the S-420iF, so we can not use backups from those robots
Does anyone have a controller backup image for this very old robot and can help us ? We need the S-420iW, R-J2, ArcTools (with must have the Weave option for this system). We can manage the reinstall on our own (can use the SRAM cards or kfloppy).
Please send to: piotr@buczynski.eu if possible.
Best regards
Piotr Buczynski