Posts by pevatech
-
-
Thank you dear panic, i will install them in the next few days all and make electrical schematic, when done i will send it to you to see which is the best configuration .
thank you again
-
Hello Guys, i have a KUKA KR200+KRC1 controller. i want to add a spindle and VFD drive to do milling, and as you know this require inputs outputs to turn on/off spindle
i got also a beckhoff devicenet BK5200 with 2x4 digital inputs modules KL1104 and 2x4 digital outputs modules KL2134 .
my question is, do i have to put any program inside the BK5200 using twincat from beckhoff, or just connect the deviceand module to the kuka devicenet connector X943.1 in parallel with the existing one and add resistor to the BK5200 devicenet bus, please advise, i'm new in this