Hello All,
i have fanuc s420f that I calibrated with the help of this forum posts, but I didn't find any manual for programming robot .
can anybody help me in finding programming manual for R-H controller robot?
thanks in advance for any help.
Hello All,
i have fanuc s420f that I calibrated with the help of this forum posts, but I didn't find any manual for programming robot .
can anybody help me in finding programming manual for R-H controller robot?
thanks in advance for any help.
hi everyone
i have problem on S3- IRB6000 M93
after starting the robot at the end off loading ;EN signal on system board and computer board flashing and off .
without any fault signal on them or error massage
please guide me where is the problem from
Thank you
hi everyone
on a stoke IRB6000-M93 robot with s3 controller
when start the robot out of limited range just for axis 1, shown this error.
(( 597 Drive unit current high 1 ))
replacement the board (DSQC 236) to no avail
the cables are Healthy
in this small range robot Almost works
please guide me which parameters or other i have to check
thank s alot ......
hi everyone
i have problem on IRB6000-M91 robot with s3 controller.
after loading robot when i push deadman switch on teach pendent no happen anything (without Show error)
but LIM signal on saftyboard (DSQC228) is off
saftyboard and TP are OK (tested on same robot)
please guide me Where do check to solve problem.
thank s alot ...........