Yes, I have the 24VDC at the 5 pin connector on the front of the card. I just did an all software install with reburn media provided by fanuc to install torchmate. The DNET is for arclink communications with a Lincoln powerwave.
Posts by aarond
-
-
I have a 100ib with RJ3 controller. On cold start the devicenet motherboard powers up with four green LEDs at the top but no LED on either the DNP or DN3 daughterboards. I've tested both boards in other controllers and they work, and I have 24VDC on the CAN header on the front of the board. I'm pulling my hair out and of course I have a deadline for commissioning.
Advertising from our partners
