Posts by ZBJxC

Excellent! thank you!

I'm making a .CM and am curious if there is a way to set interconnects via .CM?

Alright, I got one more.

set Zero % Override to "TRUE" via system variables

I tried $MCR.$OVRZERO_ENB ... I don't believe that is the right SV, and cannot fond the correct.. thanks in advance!!

Thanks HawkME!!!

I'm writing a .CM file and cannot figure out how to set the Program select mode through the variables.

Under $SHELL_CFG. $SEL_TYPE I can change the mode from PNS to RSR and STYLE, but NOT "OTHER".

Anyone able to help me out?

I just ran into this issue. One of my electricians hot swapped out my Crma58 and 59. Part of the issue was that he hot swapped them at all. The other was a wiring issue in the cable. I powered it off, swapped the fuse on the main board, and checked the wiring. Made a change to the Input wiring, powered up and was off to the races.

Long story short, if you have propitiatory I/O check the wiring on CRMA58 &59, check/change the fuse on the main board.

Don't know if this will help anybody, but at least it's an answer, and not more questions about the situation.

Quote from rumblefish

Plus to non plus doesn't work as far as I know. I've had to re enter alot of data when going the other direction. (Non to Plus). Bummer since it was a repeat job. Maybe it's header info in the var file.

So I ended up writing a karel pgm to load all the comments fo i/o and PR's and R's but thats as far as i got. I was able to load all the .TP no problem and i had to manually re-enter all the R and PR values. kind of a pain but at least i didnt have to re-comment everything as well

I am getting the same error.

I'm going from 9.1 ib+ to a 8.3. is there a way around this?