Hi All
have purchased a C3G controller and smart S2 robot, and my problems begin when I start the control box
it loads up to. *warning* checksum invalid on SCC0.
then gets to the BOOTMON enviroment
I have read the manual and it ask me to enter. CF C3G LOAD at that stage then press enter.
i do that and then next line
[Bmon] Error: $2805 CLI - Too many parameters.
and that is all that i can get from the pendant
I have tried to connect with a PC through the 25 pin plug at the front of machine but have had no luck getting in, more then likely doing it wrong. but am very open to suggestions
( i believe i have all the floppy disks with the system software and emulater ) from what the manual says that if i can establish a connection, that would be the best way to load the system software (if thats whats needed)
I am new to all this and happy for any ideas.
Thanks in advance Simo