On my company-administrated laptop with Win 10 V.20H2 I had to install as a local admin and start RG once as admin as well. After that I'm able to run it as a regular user
Posts by CarstenB
-
-
There are a few things we needed to do to also get remote start via PNS from an external PLC working with RoboGuide:
1. Set variable $RMT_MASTER to "0" (we have to do that after every reboot)
2. You can't set UIOs directly - use DI/DOs and configure them to the same rack/slot/start as the UIOs
3. UIs and corresponding DIs need to be configured to rack 34 slot 1 (Rack 34 are the Flags)
4. Do not simulate DIs used for UIs
5. We needed to simulate all other DIs and GIs we wanted to set from an external PLC
6. Make sure to set the simulation mode in RoboGuide (Run Configuration) to "No UOP Control" - Available from RoboGuide 9.1 Rev.G
Good Luck!
-
MOLN4R's solution worked for me as well on V9 Rev.K