Hello everyone
Can someone send me please link to download Robinstall software?
I need to build a system for a robot S4C+
I have a robot with robotware 3HAC6811-2.10
Many thanks to anyone who can help me
Hello everyone
Can someone send me please link to download Robinstall software?
I need to build a system for a robot S4C+
I have a robot with robotware 3HAC6811-2.10
Many thanks to anyone who can help me
hello black
Can you please send me the link for download of robinstal?
thanks a lot
I have problem with the EL6731 Profibus DP Master the red LED blinking
And I get on the TP of the robot 3 alert messages
1. SYS-X44_PB-Master1 : Profibus master error in module (addr.=2- CM 1242-5) (error code : 7-config fault)
2. Error on writing , driver :SYS-X44_PB-Master1
3. Error on reading , driver :SYS-X44_PB-Master1
I think the hardware is fine
to the PLC I added a card CM 1242-5 Profibus DP slave and Inside the PLC I defined to slave connection
on the robot i have EL6731 Profibus DP Master
on the WorkVisual i defined the I/O with the same number of byte like in the PLC
Hello panic mode
Thanks for your response
I have WorkVisual 3.1 and controller KRC 8.2.20 with EK1100 Ethercat coupler and EL6731 Profibus DP Master
i want to connect communication between the robot to siemens S7-1200 PLC
on the side of the PLC i have:
S7-1212 DC/DC/DC
CM 1242-5 Profibus DP slave
I connected the the robot to the PLC and I entered all the settings
But I get 3 alert messages on the robot
1. SYS-X44_PB-Master1 : Profibus master error in module (addr.=2- CM 1242-5) (error code : 7-config fault)
2. Error on writing , driver :SYS-X44_PB-Master1
3. Error on reading , driver :SYS-X44_PB-Master1
I would happy to get advice from you on how to resolve the issue